StencilScale
All tattoo stencils

Fern Tattoo Stencil

A narrow fern outline with a rising curve and staggered leaflets. Set its width, then use the height readout to check the full length.

Fern linework with alternating leaflets and a curved stem Download transparent PNG

Size the artwork for your proof

Because the frond is tall and narrow, start with the target height from your placement sketch. Enter a width, look at the calculated height, and adjust the width until both dimensions fit. For an initial digital proof, 55 mm wide shows the spacing between the leaves along the stem.

Check the linework on paper

Check the small paired leaflets near the tip and the places where the leaves meet the main stem. On a small version, ask whether fewer clearly separated leaves still capture the sweep of the frond. Use a recognizable bottom leaf to confirm left and right. As you adjust height, watch the sheet count for long layouts.

Make a print PDF

Download the transparent PNG and open it in the tattoo stencil maker. Use Clean drawing, compare the preview with the PNG, and set the width and paper size. Download the PDF and use the actual-size print guide to measure the 50 mm line on your paper proof.